kbob, 2 months ago Yeah, so I started over. Now I'm tying components together with rigid joints and tying them to points on sketches whose measurements use parameters. This is the measurement I tweaked that blew my model up last time... Maybe I should hashtag this thread. #Fusion360 #MCAD Video of a Fusion 360 window. The model is an IKEA LACK table with an orange box at each corner. I change the parameter "LACK_leg_inset" from 27.5 to 127.5 millimeters, and the tablre legs and boxes jump 100 mm in the right directions. Then I change it back, and they all move back.
Yeah, so I started over. Now I'm tying components together with rigid joints and tying them to points on sketches whose measurements use parameters. This is the measurement I tweaked that blew my model up last time...
Maybe I should hashtag this thread. #Fusion360 #MCAD
Video of a Fusion 360 window. The model is an IKEA LACK table with an orange box at each corner. I change the parameter "LACK_leg_inset" from 27.5 to 127.5 millimeters, and the tablre legs and boxes jump 100 mm in the right directions. Then I change it back, and they all move back.