kbob, 5 months ago

Of course, I've jinxed myself now. The next nine pieces will fail in every imaginable way, mostly by warping.

#3DPrinted

kbob, 5 months ago

The next ABS piece came out fine, but for my hubris, I'm now getting warped PLA. This is just a solid block about 80mm wide. All four corners lifted.

#3DPrinted

kbob, 5 months ago

Next in the hubris awards, I have a print that ran out of filament 1/3rd of the way through.

I'm still laughing...

#3DPrinted

kbob, 5 months ago

The next failure was a modeling error. I used a negative offset instead of a positive, so the thing came out 4mm too small. (No photo, sorry.)

#3DPrinted

kbob, 5 months ago

Winter morning timelapse.

This is the last build plate for the V block project. I've been doing these off and on between other prints.

#3DPrinting #OctoPrint

Timelapse as three screws are printed. Partway through the print, a sunbeam sweeps across the scene.

kbob, 5 months ago

Here's the complete set. All ABS. I decided to duplicate the arches and screws, as I think repeatedly popping the feet on will wear them out.

Now I'm out of black ABS. And that's great. I'm done with ABS.

#3DPrinted #ToolsForTools

chrishuck, 5 months ago

@kbob Those are badass!