@withoutclass
If you haven't updated in awhile, emerge the new glibc, reboot, then emerge GCC. I also had to explicitly set "march=raptorlake" on one of my systems vs "native". ☹️
@ScottE I did see some folks having to do that on the forums while I was poking around a bit. It must've been some error the devs found because between yesterday and today, a new emerge sync corrected the problem for me
@gabrielesvelto I ended up doing an emerge sync to see if there had been an update and now things are just installing no problem so there must've been a fix.
@gabrielesvelto I'm going to start looking at these later. Unfortunately I've run out of time for now. I am definitely considering converting to his system over to binary packages since it's a low power mini PC. Thank you for the suggestions.
@gabrielesvelto Maybe I need to sync and retry. The error isn't very clear, but it's failing during the install phase after compiling for some time.
I started over, redoing the steps from the news/install guide and am compiling gcc again so I'm hoping that it works this attempt. If not I'll move to heavier troubleshooting.
@withoutclass I saw everyone post about their profile 23 upgrade on reddit and here. It had me a little hesitant on finishing up my Gentoo install on my laptop. I want to see it on my desktop first. Maybe make that a binhost too.
@Wyatt My primary laptop had no problem at all, which is a more complicated installation compared to my mini PC, that is on a bare bones amd64 profile with openRC surprisingly.
@withoutclass my preferred profile. Last year I decided I wanted a stupid spicy build... Hardened, LLVM, musl, openrc... That lasted a week. I was in too deep.
Add comment